• Activity
  • Votes
  • Comments
  • New
  • All activity
    • Showing only topics with the tag "a30t". Back to normal view

    1. 3D printer troubleshooting advice

      ~hobbies Ask (advice)
      A little over a year ago I was gifted a Geeetech A30T. I did a couple of prints with it, but haven't had a ton of use for it. My last print was about 5 months ago. I have another print I'm trying...

      A little over a year ago I was gifted a Geeetech A30T. I did a couple of prints with it, but haven't had a ton of use for it. My last print was about 5 months ago. I have another print I'm trying to do today, but the printer doesn't extrude. It goes through the motions, but that's it. If I set the nozzle to "Clean" mode, then some extrusion comes out. The load/unload motor for the filament spool works. I've tried unloading/reloading the filament spool. I did a manual level on the bed. Any suggestions on where I may be going wrong?

      5 votes