Someone recently asked me to replace the battery in their old iPod, and I found myself wondering what I should do with the old battery. It still works, but has less capacity than when it was new....
Someone recently asked me to replace the battery in their old iPod, and I found myself wondering what I should do with the old battery. It still works, but has less capacity than when it was new. So I looked around my workshop and found some of these surface mount LEDs and decided to test the limits of my soldering skills and make a flashlight out of them.
These LEDs are very hard to solder, since they're surface-mount and the pads are on the bottom of the LED. They were never meant to be soldered by hand, but rather placed by machine onto a specific amount of solder paste, which is then baked in a fancy oven at very specific temperatures for very specific times. To solder these by hand, you need to create a liquid puddle of solder and sorta float the LED on top, while being careful to not short the pads which are very close together as well as not overheating the LED. The temperature the plastic melts at seems to be only a few degrees higher than the solder melts at.
I wired up 5 of the LEDs in parallel, each with its own 6.8ohm resistor wired in series with the LED. This should limit the current to 150mA per LED. I hot glued this in place, as well as a lithium battery charging circuit I got off ebay for a dollar. Here's one such listing.
I slapped on a pushbutton, and Bob's your uncle! It worked first try!
Here's a blurry picture of the finished product. I'm pretty proud of how it came out, considering how tiny and fiddly the soldering was. And, I think I'll actually get some use out of it too. The battery ought to last at least an hour of runtime, and the thing is seriously bright.
Anyone here into electronics as a hobby?
Edit: Better-ish pic: https://i.imgur.com/Kxqy1jg.jpg
No potatoes were harmed in the making of this photo.
